Boots On The Ground #1 DTF Transfer

Adult screens are approximately 11x11 inches

PRESSING INSTRUCTIONS FOR DTF TRANSFERS:

Pre-Press Garment for 5 seconds to get out any moisture
Temp: 325-350°F
Pressure: Heavy  (if print doesn't stick, this is likely the biggest reason why.  Make sure your press is on heavy pressure!)
Time: 10-30 Seconds
Peel: Hot

• Do not use butcher paper or any cover over this transfer when pressing
• A commercial grade heat press is highly recommended (no iron, Cricut EasyPress)

TRANSFER STILL NOT ADHERING? TRY THESE ADDITIONAL TIPS

1. Lightly lift the transfer at the corner to see if the design adheres, if not, increase the temperature by 5-10  degrees and repress for 10- 30 seconds. Continue this until you find your sweet spot.

2. Don't press over a raised neckline, this can cause an uneven press.

3. Pressing pillows can assist in providing an even press.

4. Investing in a heat gun will let you know if your heat press is heating up evenly.

*Please note the time and temp are suggested and you may have to adjust based on your own presses best settings.

ALL SALES ARE FINAL, We are not responsible for any application mishaps. Make sure you are following pressing instructions. We recommend ordering a few extras if this is your first time using our transfers.

*****TO ACCESS THIS FREE MOCKUP, JOIN  OUR FREE FACEBOOK GROUP @ CRAFT SISTERS UNIVERSITY. GO TO THE GUIDES TAB AND THE MOCKUP IS IN THE GUIDE TITLED: MOCKUPS-May 9th RELEASE*****